Skip to content
Exclusive agent of MECH products in Saudi Arabia
Store Request a quote

Glossary of Fire Protection and Piping Terms: English – Arabic

More than 70 terms on valves, grooved fittings, sprinkler systems and testing, with the Arabic equivalent and a short definition of each.

Technical terms in fire protection and piping are used in English in specifications and drawings, and in Arabic on site and in correspondence, and translations vary from person to person. This glossary gathers 71 common terms with one consistent Arabic equivalent and a one-line definition, in four groups.

Key points

  • 71 terms on valves, grooved fittings, systems, and approvals and testing.
  • The Arabic equivalent is the one used throughout our guides and product pages.
  • Each main term has a detailed guide in our technical library.

Valves

TermArabicDefinition
Gate valveمحبس بوابةOpens and closes with a gate moving across the flow; used for full isolation.
OS&Y (Outside Screw & Yoke)محبس بوابة بعمود صاعدThe thread is outside the body and the stem rises on opening, so its position is visible.
NRS (Non-Rising Stem)محبس بوابة بعمود ثابتThe stem does not rise; used with an indicator post or supervisory switch.
Resilient wedge / seatبوابة مغلّفة بالمطاطA rubber-encapsulated wedge that seals without a cavity at the bottom.
Butterfly valveمحبس فراشةA disc that turns a quarter turn; light and short face to face.
Check valveمحبس عدم رجوعLets water pass in one direction only.
Swing check valveمحبس عدم رجوع متأرجحA hinged disc that swings open with the flow.
Wafer check valveمحبس عدم رجوع ويفرA thin valve clamped between two flanges.
Alarm check valveمحبس الإنذارA check valve that triggers an alarm when water flows in a wet system.
Deluge valveمحبس غمريOpens on a signal to supply a network of open sprinklers.
Pressure reducing valve (PRV)محبس خفض الضغطReduces outlet pressure to a set value.
Pressure relief valveمحبس تنفيس الضغطOpens to discharge water when a set pressure is exceeded.
Y-strainerمصفاة YTraps debris ahead of valves and equipment.
Ball valveمحبس كرويA bored ball turned a quarter turn; common in small sizes.
Test and drain valveمحبس الاختبار والتصريفUsed to test a floor’s flow and drain the system.
Post indicator valve (PIV)محبس بعمود مؤشرA buried valve operated from an above-ground post that shows its position.
Wall indicator valve (WIV)محبس بمؤشر جداريOperated from an indicator mounted on a wall.
Air release valveمحبس تنفيس الهواءExpels air trapped in the pipework.

Grooved fittings and couplings

TermArabicDefinition
Grooved couplingجلبة محززةA two-piece housing and gasket joining two grooved pipe ends.
Rigid couplingجلبة ثابتةPrevents movement between pipes, behaving like a weld.
Flexible couplingجلبة مرنةAllows limited deflection and expansion.
Reducing couplingجلبة نقاصJoins two pipes of different sizes.
Mechanical teeقسام ميكانيكيTakes a branch from a run pipe through a drilled hole, without welding.
Grooved flange adaptorمحوّل فلنجة محززTurns a grooved end into a flange to connect a valve or equipment.
End capسدة نهايةCloses the end of a line.
ElbowكوعChanges line direction by 90°, 45° or another angle.
Teeمشترك (تي)Takes a branch at a right angle.
Concentric reducerنقاص متحد المركزTransitions between two sizes on the same axis.
Eccentric reducerنقاص لامركزيTransitions between sizes with one flat side; prevents air pockets.
Gasketجوان (حلقة إحكام)A rubber ring that seals the joint; usually EPDM for water.
Roll groovingتحزيز بالدرفلةForms the groove by pressing, without removing metal.
Cut groovingتحزيز بالقطعForms the groove by removing metal from the pipe wall.
Ductile ironحديد مرن (دكتايل)Cast iron with spheroidal graphite; stronger and less brittle.
Malleable ironحديد قابل للطرقThe usual material for black and galvanised threaded fittings.
NPT / BSPTسن أمريكي / سن بريطانيTwo tapered pipe thread standards; not interchangeable.

Systems and components

TermArabicDefinition
Wet pipe systemنظام رطبPipes are always full of water.
Dry pipe systemنظام جافPipes hold compressed air; for areas exposed to freezing.
Pre-action systemنظام سابق التشغيلFills with water after a detector signal.
Deluge systemنظام غمريOpen sprinklers that all discharge together.
SprinklerرشاشOpens with heat and spreads water over a set area.
K-factorمعامل KRelates sprinkler flow to pressure: Q = K × √P.
RiserصاعدThe vertical pipe that feeds the floors.
Cross mainخط رئيسي أفقيFeeds the branch lines.
Branch lineخط فرعيThe line on which sprinklers are installed.
Fire pumpمضخة حريقRaises water pressure to supply the system.
Jockey pumpمضخة موازنة الضغطA small pump that maintains system pressure.
Fire department connection (FDC)وصلة الدفاع المدنيLets fire engines feed the system from outside.
Fire hydrantحنفية حريقAn outdoor water outlet for fire crews.
Landing valveمحبس خرطومAn outlet for a fire hose inside the building.
Water flow indicator / flow switchمؤشر تدفق المياهSends a signal when water flows in the pipe.
Supervisory (tamper) switchمفتاح مراقبةAlerts if an isolation valve’s position changes.
Pressure switchمفتاح ضغطOperates when pressure reaches a set value.
Anti-vortex plateمانع الدوامةA plate at the suction outlet that prevents an air vortex.
Puddle flangeفلنجة عبور (بادل فلانج)A flange on a pipe passing through a concrete wall to stop leakage.
Hazard classificationتصنيف الخطورةClassing an area (light, ordinary, extra) to set water density.
Design densityكثافة التصميمWater quantity per unit area.
Hydraulic calculationحسابات هيدروليكيةCalculating pressure and flow to confirm the supply is adequate.

Approvals and testing

TermArabicDefinition
UL Listedمدرج لدى ULTested by UL and shown in its listings for a specific use.
FM Approvedمعتمد من FMTested and approved by FM Approvals.
Submittalملف اعتماد الموادDocuments submitted to the consultant to approve a material.
Compliance statementبيان المطابقةA table comparing the specification with what the material offers.
Working pressureضغط التشغيلThe highest rated pressure for continuous use.
Hydrostatic testاختبار هيدروستاتيكيTesting the network with water above working pressure.
Flushingغسيل الشبكةRunning water through to remove debris before service.
ITMالفحص والاختبار والصيانةThe periodic maintenance programme under NFPA 25.
AHJ (Authority Having Jurisdiction)الجهة المختصةThe body with approval authority, such as Civil Defense.
PN16ضغط اسمي 16 بارA European pressure rating for valves and flanges.
Class 150 / Class 125فئة 150 / فئة 125American pressure classes for flanges.
DN (Nominal diameter)القطر الاسميA number that names the size, not a measured diameter.
OD (Outside diameter)القطر الخارجيThe pipe’s actual outside diameter.
Schedule (Sch)سماكة الجدار (سكجول)A number that indicates pipe wall thickness.

Note

When writing a specification or submittal in Arabic, put the English term beside the Arabic on first mention, so the designer, supplier and inspector read it the same way.

Frequently asked questions

What is the difference between DN and outside diameter?

DN is a nominal size number; the outside diameter is the actual measurement. For example DN100 corresponds to 4″ with an outside diameter of 114.3 mm. See the size converter.

Are OS&Y and NRS different kinds of valve?

Both are gate valves; the difference is how the stem moves. See the detailed comparison.

What is the difference between UL Listed and FM Approved?

They are two independent bodies that test and approve products. See how to verify approval.

References

  • NFPA 13 — Standard for the Installation of Sprinkler Systems.
  • NFPA 25 — Standard for the Inspection, Testing, and Maintenance of Water-Based Fire Protection Systems.
  • SBC 801 — Saudi Fire Code.

Definitions are shortened for clarity; the formal definition of each term is in its own standard.

Send your BOQ and get a detailed quotation

Upload your BOQ or specs and our technical team will match products and prepare the offer.