Skip to content
Exclusive agent of MECH products in Saudi Arabia
Store Request a quote

MECH BRASS AIR VENT VALVE MODEL : B21X

Model B21X

Connection ends
Threaded ISO 7-1
Working pressure
PN16
Temperature range
0 – 80 °C
Sizes
1/2" – 1" (DN15 – DN25)
Request a quote for this product
Or buy from the online store
Certificates & approvals

Ask us for this product's certificates.

SIZES & DIMENSIONS

Sizes & dimensions

SizeDNA (mm)B (mm)C (mm)D (R)
1/2"DN153019751/2
3/4"DN203019753/4
1"DN253019751

The MECH brass air vent valve, model B21X, sizes 1/2″ – 1″ (DN15 – DN25), working pressure PN16. It vents air from high points of water and heating lines. This guide explains what it does and how it works, related models, technical data, the critical point in selection and installation, and common mistakes.

At a glance

  • An automatic air vent has a float that opens the outlet when air collects and closes it when water arrives.
  • Sizes 1/2″ – 1″ (DN15 – DN25).
  • Working pressure PN16.
  • Connection: Threaded ISO 7-1.
  • Operating temperature: 0 – 80 °C.

Brass air vent valve: what it does and how it works

An automatic air vent has a float that opens the outlet when air collects and closes it when water arrives.

It is fitted at high points, on manifolds and on hot water and HVAC lines.

Technical data

Specification of model B21X
ItemSpecification
Connection endsThreaded ISO 7-1
Working pressurePN16
Temperature range0 – 80 °C
Sizes1/2″ – 1″ (DN15 – DN25)

Dimensions for every size are in the size table at the top of the page.

Where to install it

Install vertically at the highest point with an isolating valve for maintenance.

Caution

Do not fit it tilted or at a low point.

Installation steps

  1. Check the thread type (ISO 228 parallel or NPT / ISO 7-1 taper) matches the pipe, and use the sealant or gasket suited to that thread.
  2. Hold the valve with the wrench on the end being tightened, not on the body or handle.
  3. Do not over-tighten, so the brass body is not distorted.
  4. Operate the valve after installation to check movement and sealing.

Common mistakes

  • Mixing parallel and taper threads.
  • Tightening by the valve body or handle.
  • Over-tightening the brass body.

Files and ordering

On this page: Product datasheet, MECH Brass Valves Catalogue. Add the product to your request list with size and quantity and we send a quotation, or build a submittal PDF for the consultant. Fu-Mech is the exclusive MECH agent in Saudi Arabia.

Frequently asked questions

Where is it installed?

At the highest points of the line and on manifolds.

Does it need maintenance?

Periodic inspection and cleaning.

What is the working pressure of model B21X?

PN16 per the product data. The pressure for each size or listed model is in the size table and datasheet.

What end connection does it have?

Threaded ISO 7-1. Choose the connection that matches the adjacent pipe and fittings.

References

  • ISO 7-1 — Pipe threads where pressure-tight joints are made on the threads
  • MECH catalogue — MECH brass valves

This guide is general information to help with selection. Figures come from the product data on this page and the MECH catalogue; final design is by the project’s approved designer to the applicable standards and the project specification.