The MECH test & drain valve, model Y-4030, sizes 1″ – 2″ (DN25 – DN50), working pressure 300 PSI. It combines alarm testing and system draining in one valve with a sprinkler-equivalent test orifice. This guide explains what it does and how it works, related models, technical data, the critical point in selection and installation, and common mistakes.
At a glance
- A test and drain valve has three positions: off, test and drain.
- Sizes 1″ – 2″ (DN25 – DN50).
- Working pressure 300 PSI.
- Connection: ASME B1.20.1.
- Operating temperature: 0 – 80 °C.
Test and drain valve: what it does and how it works
A test and drain valve has three positions: off, test and drain. In test it passes water through an orifice with the K-factor of one sprinkler (K-5.6 per the product data), simulating an open sprinkler to test the flow switch and alarm; in drain it empties the system.
It has a sight glass to see the flow during testing and is normally fitted after the flow indicator on each floor or zone.
Technical data
| Item | Specification |
|---|---|
| Design standard | FM1625, UL258 |
| Connection ends | ASME B1.20.1 |
| Working pressure | 300 PSI |
| Temperature | 0 – 80 °C |
| Orifice | K-5.6 |
| Sizes | 1″ – 2″ (DN25 – DN50) |
Dimensions for every size are in the size table at the top of the page.
Test orifice
The test orifice must match the smallest sprinkler K-factor in the zone so the test represents one sprinkler opening.
Caution
Pipe the drain to a point that can take the full flow.
Installation steps
- Install after the flow indicator with the arrow in the direction of flow.
- Pipe the drain to a suitable outlet.
- Test the alarm in the test position, watching the sight glass.
- Return the handle to off after testing.
Common mistakes
- A test orifice larger than the sprinkler K-factor.
- Draining to a point that cannot take the flow.
- Leaving the handle in test.
Files and ordering
On this page: Product datasheet, Installation & operation manual, MECH Fire Protection Valves Catalogue (UL/FM). Add the product to your request list with size and quantity and we send a quotation, or build a submittal PDF for the consultant. Fu-Mech is the exclusive MECH agent in Saudi Arabia.
Frequently asked questions
Why a K-5.6 test orifice?
To simulate the flow of one K5.6 sprinkler, the common standard sprinkler K-factor.
Where is it installed?
After the flow indicator on each floor or zone.
What is the working pressure of model Y-4030?
300 PSI per the product data. The pressure for each size or listed model is in the size table and datasheet.
Is it UL / FM approved?
No approvals are listed for this model in the product data. If your project needs a specific approval, ask us before ordering.
What end connection does it have?
ASME B1.20.1. Choose the connection that matches the adjacent pipe and fittings.
References
- ASME B1.20.1 — Pipe Threads, General Purpose, Inch (NPT)
- MECH catalogue — Product datasheet
This guide is general information to help with selection. Figures come from the product data on this page and the MECH catalogue; final design is by the project’s approved designer to the applicable standards and the project specification.




